Board Boss

Board Boss

How could I build my own mini pedal?

I: BOSS AC-3 Acoustic Simulator Compact Pedal BOSS RC-2 Loop Station BOSS DS1 Distortion Compact Pedal Pedal POD compact pocket too have a Boss Psa adapter, and Daisy Chain cables and all cables you need. Its just the construction of a board good.

I your foot with a piece of Lexan sheet of acrylic or clear preference 1 / 2 "thick. Buy a piece that is large enough to contain all the pedals, plus space for an addition or two. Organize the pedals in the order in which plugs into the signal chain or what makes sense for you and enter your location in the plastic with tape or by tracing around the perimeter. To connect the pedals propose removing the screws and rubber pads that secure the bottom cover at. Then, while holding the pedal in line with tape or scribe marks the sites of screw holes. Drill holes at these locations and ride the pedals with longer screws of the same threads that were removed from the pedal. Be sure to leave the metal bottom of the pedals in place between the plastic and pedals, because without doubt, provide electrical protection to keep noise levels low. You can take some of the Rubber Feet removed from the pedals and attach to the Board so that it does not slide around or Sea of the word. Alternatively, if you want to use plywood for the Board that is fine, but you have to dial the pedal mounting holes with a different method. Take a sheet of paper and rub a pencil along the edge of the pedal to track the perimeter. then draw the locations of the holes in the paper or holes through them and use the document as a template to drill holes. If you end up with misalignment problems of drill holes and put large washers on the screw head. You may also want to mount a handle on one or both ends to make it easier to carry. You might also consider building in some kind of enlightenment. The customization possibilities are endless. Have fun.